For Inquiries Send
Email To:


Kevin Slaby
tech@baselinesuspensions.com


NEW DESIGN
Prolaunch #2 Chromemoly control arms that are machined from solid HEX bar then
Zinc Plated.
These new control arms are now STANDARD EQUIPMENT
in the Prolaunch #2 kits.

For cars running 9's and well into the 7's the Prolaunch #2 is recommended.
This kit uses larger 5/8" control arm bolts to withstand the abuse of tire shake
better than the usual 1/2" bolts supplied with other kits plus with cars
making this much horsepower tire shake can be a major problem.
**Optional 1/2" bolts available upon request.
For best results and to get the suspension set up correctly for Drag Racing it is recommend that there is some way to alter the ride height of the rear of the car. Adjusting the rear ride
height alters the rear control arm geometry thus moving the Instant Center (IC).
Lengthening the IC changes the amount of leverage the suspension has to lift the
nose of the car and it changes the amount of tire loading during the launches.
Some ways that can be done to adjust the ride height are the use of coilovers, coilover conversion, weight jacker type LCA's, cutting springs or adding weight. Doing this is not necessary but it's recommended for best results.



Prolaunch #2


Track Locator


Prolaunch #2 and Track Locator


Prolaunch #1


Prolaunch #1


Prolaunch #1



For Inquiries Send
Email To:


Kevin Slaby
tech@baselinesuspensions.com

*Please send details about the cars
suspension, tranny, motor, tires, ET, etc
so you can be better helped.
Thank You

Copyright 2002 Baseline Suspensions, Inc. all rights reserved.
No part of this site may be reproduced without prior written consent.
Prices Subject to change without notice.